Fedora ARM Shopping List
Revision as of 10:59, 13 July 2011 by Chris Tyler (talk | contribs) (Created page with '= July 2011 = Equipment shopping list: * [http://www.digikey.com DigiKey] ** 17 [http://search.digikey.com/scripts/DkSearch/dksus.dll?WT.z_header=search_go&lang=en&site=us&keyw…')
July 2011
Equipment shopping list:
- DigiKey
- 17 PandaBoards
- 15 power leads/barrel connectors
- Everything on the motion sensor parts list
- Canada Computers
- 17 8GB SD cards
- McMaster-Carr
- 4 stainless steel threaded rods - #4-40 x 24"
- 2 packs of 6 acorn nuts - #4-40 stainless steel
- 1 pack of 1.25" nylon spacers
Also needed but not yet sourced:
- Network cables (recommend Tiger Direct or Canada Computers)
Questions:
- Do we need another switch?
- Should we use the existing ATX power supply for both stacks, or buy a separate one for the new stack?
- What colours of cables should we use? Buy 5' again?
- Our existing numbering scheme is running out of numbers. Should we switch to groups of 10 machines? (i.e., cdot-guru-5-{0..9}?) Or change the way we map unit numbers to IP addresses?
- Do we need anything else? How about...
- UPS capacity?
- NICs?
- Disks?
- ???
Note: hex nuts, 0.25" nylon spacers, and heat-shrink tubing are left over from first PandaStack
