1. Edit your "/etc/fstab" and change the following lines file system to "auto" from "nfs":" /dev/root / nfs defaults 1 1"

2. Use yum to install "rpcbind" and "nfs-utils" and make sure that the "rpcbind" and "nfs" services are started at boot.: yum install rpcbind nfs-utils chkconfig rpcbind on chkconfig nfs on

3. Create a the <code>/share</code> folder where you would like to mount the HongKong NFS share. In these examples i will be using " mkdir /nfsshare" as the mounting point.share

4. Run Create an <code>/etc/hosts</code> entry for HongKong using both the command hostname and the FQDN: echo "mount 192.168.122.1:hongkong hongkong.proximity.on.ca" >>/varetc/wwwhosts # VMs only echo "192.168.1.254 hongkong hongkong.proximity.on.ca" >>/htmletc/yum/arm_built /nfsshare" to test that you can successfully mount the share. Where ever I use this directory, replace it with the mount point of your choicehosts # physical hardware only

5. If it mounts correctly it will give no output. Run Create an fstab entry to mount the <code>/share</code> directory from HongKong: echo "mounthongkong:/share /share nfs defaults,noauto 0 0" command to check that it has been successful.>>/etc/fstab

6. Add Test that you can successfully mount the following line to "share: mount /etc/fstab" to auto mount the share every time the VM boots.

"1927.168If it mounts correctly it will give no output.122Run the "mount" command to check that it has been successful.1:/var/www/html/yum/arm_built /nfsshare nfs defaults 0 0"

78. Reboot your vm Add a line to make sure /etc/rc.d/rc.local to mount the share automatically at boot time (note: this will fail if the nfs NFS share is properly mounted not available at boot, but the boot will proceed. To restart your vm log into hongkong as root and run The alternate approach of mounting at boot time via <code>/etc/fstab</code> will cause the following commandsboot to stall/fail if the NFS share is not available at boot): echo "mount /share" >>/etc/rc. As an example i will use arm-001-002, replace this with your VMd/rc.local

#9. Optional/recommended: Reboot your vm to make sure the nfs share is properly mounted at boot. To restart your vm log into hongkong as root and run the following commands. As an example i will use arm-001-002, replace this with your VM. First, on the VM: poweroffThen on the host (HongKong): virsh destory arm-001-002# virsh start arm-001-002